U600

This model is a domestic shoe shine polisher with an intermittently running motor. The motor cycle runs continuously for 5 minutes, then remains off for 5 minutes before restarting. The motor has an automatic thermal overload cut-out, which stops the machine in case of excessive force that could cause overheating. If the overload is triggered, please wait about 10-15 minutes before using the appliance again (depending on the room temperature).

By looking through the slit in the wax box and using the indications, you will see if you need to put wax back into the container.
If you need to refill, you can unlock the cream dispenser and move it outwards to open the container.
Take the container out and fill with cream. Put the spring and the steel ball in the correct position before closing the tap again. Make sure that the drain hole at the top of the bottle is open. Otherwise the shoe cream will not run easily when you press the tap. You can remove the locking pin from the hole and discard it at the first use of your bottle. Put the cream bottle back in the compartment and lock it properly on the polisher.

To use the polisher press the on button to switch it on. This button is located on the top of the box. Pressing it once will start the polisher and pressing it again will switch it off.