IRO320

Is the plug properly inserted into the outlet? Correct
the position of the plug in the socket.
2. Is the outlet defective? Try another take.
3. Check the house fuses.
4. Is the device turned on? Set the timer (8) for one hour.

Are the ventilation grilles (9) covered or
clogged? Release the ventilation grids (9).
2. The device has an automatic shut-off function.
security. It turns off automatically in the event of overheating.
Let the appliance cool down and switch it on again.
3. Has the device been dropped? The device has a switch
safety device which is activated if the device is dropped.
Put the device back in position and turn it on again.
4. Has the chosen time elapsed? Set the timer again
(8) at the desired time.

You may notice a slight odor caused by
manufacturing residues from the first use of
the device. However, this is harmless and will stop when
you will use the device.

1. Clean the device and the nylon balloon if
necessary, with a slightly damp cloth and a
little mild detergent if necessary. Then wipe
completely with a dry cloth.
2. Allow all parts to dry completely before
to put them away.
3. Store the device in a clean, dry place.
protected from direct sunlight and inaccessible to
children and animals.

The appliance is primarily intended for machine-spun laundry! If the laundry was washed by hand or
not wrung out must be ironed, let it dry a little first.
- The drying / ironing process takes about 10 minutes for a wrung-out shirt.
However, the duration may vary depending on the fabric and its thickness.
recommend starting with a shorter time and extending it if necessary.
- The nylon balloon can be made larger or smaller in size using the zippers.
For small sizes, zippers should be attached. For plus sizes
large, zippers should be open on both sides.
- Buttons that are spread apart may cause the button strip to pucker up slightly during pressing.
ironing. Here it is advisable to smooth the button strip again by hand immediately
after the pressing process.

Yes, the Wëasy Magic Pressing Automatic Ironing Mannequin can be used on already dry clothes.

However, the results will be better if the clothes are wet.
Indeed, water vapor helps to soften folds and make clothes softer. If the clothes are already dry, the ironing mannequin will use its heating system. However, it may take longer and the results will not be as good as if the clothes were already wet.